Bovine Hoof Block Adhesive MD-200

$23.50

Call Toll Free 888-971-9691 to order.
  • Two Part Urethane Adhesive
  • Sets in 30 Seconds
  • Adhere Wooden, Rubber & Plastic Blocks
  • Longer Block Retention for Fast Recovery
  • Adhesive has Excellent Stacking Ability
  • 4 Free Mixers With Each Cartridge Ordered

Description

200 ml cartridge size. 4 free mixing nozzles included.

Instructions:

Trim, rasp or grind to balance the claw as level as possible. Sand and clean. Dry claw with a heat gun. Remove the retaining nut and plug. Before attaching the mixer, dispense a small amount to ensure that both sides are dispensing evenly. Attach mixer and secure the retaining nut. Heat the synthetic or wood block for 15 seconds with heat gun. Apply 30 to 50 ml of MD 200 on block. Position block on prepared claw. Ensure 1/8 inch to 3/16 inch width of MD 200 between block and bottom of claw. Hold until bond begins to cure; then press firmly for 30 seconds. If possible, let MD 200 cure for 2-3 minutes before releasing leg.

Recommended additional products used with this product: